![]() Movement and Coverage – Unless you are letting the paint pool and dribble for effect it is best to make sure you keep the spray can moving. An even layer of primer before painting will provide you with a good base for painting and a unified base colour to work on top of. Priming surfaces ensures a good adhesion for your paint and it is best done in two thin coats. This will knock out any paint left in the cap and helps to extend the life of a cap and also helps to prevent the nozzle clogging.Ĭlean and Prime – Before applying paint or primer to plastics, glass and hard glossy surfaces it is best to clean it of any surface dust then degrease it to ensure the best adhesion of your paint. Purge the Cap – After finishing using a colour hold the can upside down and spray for a few seconds until it sprays clear. ![]() ![]() Shake for about 15 seconds after you can hear the can rattle and that should be enough make sure everything is thoroughly mixed. Hold the can upside down to help with unseating the paint and tap the bottom of the can a few times to unseat the mixer if you cannot hear it rattling. Make sure you can hear the mixing ball bearing rattle when shaking the can to ensure the paint is mixed properly. Shake Well – If a can has not been used in a while the paint inside can settle at the bottom, and if you use it without shaking first you can end up with suboptimal coverage and a poor finish. In this article we hope to inform you about some of the best practices to observe whilst using spray paints, so that next time you pick up a spray can it should be smooth sailing. Spray paint is one of those mediums which is both simple and quite complex all at once, because there are a host of factors to consider between pressing the cap and paint hitting your painting surface.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |